DIY Project: Firewood Rack
For many of us, yards mean trees, trees mean pruning, and pruning means wood – lots and lots of wood, as it seems to multiply once you start cutting those downed limbs into more manageable pieces.
If, of course, we have a wood-burning fireplace or outdoor fire pit, we can put those fallen pieces to good use. We still have to store all that wood, however, which can be daunting. Sure, we can find an empty spot in the back of the yard and stack it in a pile, but rough piles of wood eventually fall over – they always do. Plus, firewood ideally should be stored off the ground to promote airflow. Otherwise, it may rot quickly and attract bugs, making it undesirable for use in an indoor fireplace.
The firewood rack featured here, which includes an upper area for kindling and a lower area for split logs, solves all of those problems and more. Besides keeping the firewood tidy and off the ground, it also looks great.
For brevity’s sake, when instructions state “attach,” the step includes the added suggestion of drilling appropriately sized pilots and countersinks before installing screws.
Don safety gear, and cut the 2-by-4s into lengths of 5 feet – or in half, as not all 10-foot boards actually measure 10 feet. Lay two 5-foot boards next to each other, and mark them both at 151⁄2 inches and 521⁄2 inches from the top.
Separate the two marked boards so they are 5 feet apart from outside to outside, keeping them parallel to each other. Measure diagonals: equal measurements means the boards are parallel.
Position another 5-foot-long board across the parallel boards, flush with the tops. Attach the board into place at each junction point by driving in one optional 21⁄2-inch screw, or using one 3-inch screw angled slightly so it doesn’t protrude out the back side.
Screw the 20-inch pieces of scrap 2-by-2 to the outside of the 2-by-4 and 16-inch scrap pieces, using a speed square to make sure the pieces are square.
TIP: As you add layers to the rack, you may want to use a speed square to further verify their alignment.
Position the rack in its final location. Although it’ll be stable, especially when loaded with wood, it’s still a good idea to secure it to a sturdy structure, especially if there’s any danger of children climbing on it. A 4-inch screw screwed into a framing member of the structure/building should do just fine.
Reprinted with permission from Garden Builder,by Joann Moser, published by Quarto Publishing Group. Order your copy at www.CappersFarmer.com/Store.
A Glider Comes Home
Restoring a porch glider.
Cutting Board Tablet Holder
For the cooks on your gift-giving list, this DIY project for a simple yet practical tablet holder made from a cutting board, wooden doorstop, and a Scrabble tile holder is perfect.
Build a Rustic Barn Quilt
Add country charm to your landscape or home with this DIY project for a piece of colorful quilt-pattern art.